+- Moode Forum (https://moodeaudio.org/forum)
+-- Forum: Community (https://moodeaudio.org/forum/forumdisplay.php?fid=18)
+--- Forum: General Discussion (https://moodeaudio.org/forum/forumdisplay.php?fid=21)
+--- Thread: [PROBLEM] GPIO On at boot (/showthread.php?tid=7681)
GPIO On at boot - Gruluct - 04-27-2025
Can someone tell me why the GPIO 4, 5 and 6 are on ON in boot?
I use moOde 9.3 on a Raspberry Pi 5 and I found nothing in /boot/firmware/config.txt
#########################################
# This file is managed by moOde
#########################################
# Device filters
[cm4]
otg_mode=1
[pi4]
hdmi_force_hotplug:0=1
hdmi_force_hotplug:1=1
hdmi_enable_4kp60=0
[all]
dtoverlay=vc4-kms-v3d
max_framebuffers=2
display_auto_detect=1
disable_fw_kms_setup=1
arm_64bit=1
# General settings
arm_boost=0
disable_splash=1
disable_overscan=1
hdmi_drive=2
hdmi_blanking=1
hdmi_force_edid_audio=1
hdmi_force_hotplug=1
hdmi_group=0
dtparam=i2c_arm=on
dtparam=i2s=on
dtparam=audio=on
# Do not alter this section
# Integrated adapters
#dtoverlay=disable-bt
#dtoverlay=disable-wifi
# Audio overlays
dtoverlay=hifiberry-dac8x
dtoverlay=force_eeprom_read=0
# PCI Express
#dtparam=pciex1
#dtparam=pciex1_gen=3
# Pi Touch1
#dtoverlay=vc4-kms-dsi-7inch,invx,invy
# Fan speed
dtparam=fan_temp0=50000,fan_temp0_hyst=5000,fan_temp0_speed=75
If i use: pinctrl get 4,5,6
4: no pu | -- // GPIO4 = none
5: no pu | -- // GPIO5 = none
6: no pu | -- // GPIO6 = none
But i measure a on state on these GPIOs?
I can pass them to off, so they work.
THANKS