[PROBLEM] CamillaDSP presets not updated in UI consistently

[Sehnsucht]

Selecting a config using the Quick Config Switch on the Shortcuts tab of the Pipeline Editor in CamillaDSP takes immediate effect. But when making a such a change and then  leaving this page and looking at the currently selected config on either:
1) The CamillaDSP icon at the top right of the main screen (ie the "tone control" icon to the left of the little m)
2) The selected entry on Signal Processing on the Configuration section of the CamillaDSP config page
show whatever config was set previously.

Reproduces 100% on moOde v9.2.1 on a Pi 4.

Edit: sorry, Pi 4, not 5.

[bitlab]

Only selecting a camilladsp config from the moode it self (either by the quick config menu in the top right of the main screen or at the moOde CamillaDSP config page) is currently supported. For example see thread https://moodeaudio.org/forum/showthread....1#pid57931

When running a recent version of moOde in Quick Config Switch in CamillaGUI the config selection shouldn't be available (Just checked with a fresh 9.2.1), if still available this could be a bug. To be sure no customize/manual stuff done with either moOde or camilladsp related software?

For CamillaDSP 3.0 (when it is released) I made some changes so that moOde support also the config selection from the CamillaGUI Quick Config Switch.

[Sehnsucht]

Only selecting a camilladsp config from the moode it self (either by the quick config menu in the top right of the main screen or at the moOde CamillaDSP config page) is currently supported. For example see thread https://moodeaudio.org/forum/showthread....1#pid57931

When running a recent version of moOde in Quick Config Switch in CamillaGUI the config selection shouldn't be available (Just checked with a fresh 9.2.1), if still available this could be a bug. To be sure no customize/manual stuff done with either moOde or camilladsp related software?

For CamillaDSP 3.0 (when it is released) I made some changes so that moOde support also the config selection from the CamillaGUI Quick Config Switch.

I have a totally stock install except for some tweaks to infrared-related files so I can control moOde with a remote control.
Selecting configs via "Quick Config Switch" absolutely works - it would have been a real pain to create/compare my configs without this! If this is a bug feel free to not fix it until Camilla v3 is released!

Edit: On my Pi Zero 2 W (latest version - absolutely stock in this case) I also see the Quick Config Switch although it took about 5 seconds for it to be populated.