Hi,
Over here: https://moodeaudio.org/forum/showthread.php?tid=4679 I talk about how I set up Moode to turn my AVR off and on.
For extra credit I'm trying to enable the Moode UI to control the AVR's volume via eiscp commands - while leaving MPD fixed at 0db output (since I am sending audio over HDMI).
I've looked through the code a bit, but I'm not sure that I've found the right place to "bolt this on."
- I've found 'vol.sh' but I think that script is only intended for remote / command line controls?
If someone could point me at the lines in code where changing the volume in the UI affects the volume output, that'd be a good start!
thanks!
Over here: https://moodeaudio.org/forum/showthread.php?tid=4679 I talk about how I set up Moode to turn my AVR off and on.
For extra credit I'm trying to enable the Moode UI to control the AVR's volume via eiscp commands - while leaving MPD fixed at 0db output (since I am sending audio over HDMI).
I've looked through the code a bit, but I'm not sure that I've found the right place to "bolt this on."
- I've found 'vol.sh' but I think that script is only intended for remote / command line controls?
If someone could point me at the lines in code where changing the volume in the UI affects the volume output, that'd be a good start!
thanks!
