03-03-2025, 09:12 PM
yes and no. When I add them using the filter editor, the file selector allows me to pick it. Then I change it to $samplerate$ and that is accepted. Then when I save the config that i sok. But when I load it I see filter errors and that is where I see it looking for the files in ..../configs and cant find them.
I would prefer to have sub-directories where I can store all the filters assocuiated with a config file but I'm wary to go that step until this is solved.
But I frame all this with the thought that once a config file load fails - which had already happened - other strange things such as config selector in Moode disappears and nothing will reset things - even re-boot.
I suspect what is happening is that once my faulty config file failed previous to this sequence, it shuts down some camilladsp gui service and is writing some state information into a config file. That seems to me the only way it can't recover even on a re-boot.
I am gong to re-flash the sdcard with 9.2.5 tonight and run the convert config function on it and then see if it loads. If the gui fails again, I guess we have a faulty config that is not being properly converted. If it runs then yaay!
I am generating the configs from Python based on designing sets of filters. Once I find what the problems are, I can make any changes required. I believe I saw a function in pycamilladsp to be able to check a config. I might try that as a part of this investigation. Its a question of time as it is for all of us.
Thanks so much.
I would prefer to have sub-directories where I can store all the filters assocuiated with a config file but I'm wary to go that step until this is solved.
But I frame all this with the thought that once a config file load fails - which had already happened - other strange things such as config selector in Moode disappears and nothing will reset things - even re-boot.
I suspect what is happening is that once my faulty config file failed previous to this sequence, it shuts down some camilladsp gui service and is writing some state information into a config file. That seems to me the only way it can't recover even on a re-boot.
I am gong to re-flash the sdcard with 9.2.5 tonight and run the convert config function on it and then see if it loads. If the gui fails again, I guess we have a faulty config that is not being properly converted. If it runs then yaay!
I am generating the configs from Python based on designing sets of filters. Once I find what the problems are, I can make any changes required. I believe I saw a function in pycamilladsp to be able to check a config. I might try that as a part of this investigation. Its a question of time as it is for all of us.
Thanks so much.
