[SOLVED] CamillaDSP brief "garbled" output when starting playback

[Tim Curtis]

Do you have another DAC to test with?

Can you describe in more detail what “garbled” means?

I do have a couple other DACs available. I'll give it a go and see if they suffer from the same issue.

By garbled, I mean choppy and broken up sounding. Like if you were having connectivity issues while on a VoIP call. (Make sense?)

I tried swapping in a Raspberry Pi 5 and now the output only works for a brief moment and then goes silent. If I force it to use the output defined in the pipeline editor and set that to "default", it works... but the the audio is in 48kHz. (Instead of the source 44.1kHz.)

I've never had any issues with this particular Topping DAC ever. It only started after I moved to the new release of Moode. (To confirm this, I'm also going to try putting Moode 8 back on the Pi 4.)

On a side note... I'm totally going to sponsor your Qobuz Connect project.

Very odd.

The symptoms suggests some sort of configuration issue.

To troubleshoot I would try the steps below. Just make sure no additional settings changes are made for example restoring from a backup.

1. Pi-5 and Fresh image
2. Plug in Topping DAC
3. Open Audio Config and select it as the Output device
4. Verify that playback works and there are no audio glitches or other issues

5. Open CamillaDSP Config and set Signal processing to V3-Loudness
6. SAVE
7. Verify that playback works and there are no audio glitches or other issues