Play/Pause button using GPIO Mapping (weird behaviour)

[seipersei]

Hi all,

I have a hardware button, wired to GPIO16, that I used as a play/pause button (using the GPIO mapping in Moode’s configuration page, set to Button 1 > Pin 16 > CMD “mpc,toggle”. 


The problem I have encountered is that I often need a “double push” in order to play or pause a song. Is this expected behaviour? Can it be tweaked to make it a single push?

Thanks for your help

[kuyadreiph]

Hi all,

I have a hardware button, wired to GPIO16, that I used as a play/pause button (using the GPIO mapping in Moode’s configuration page, set to Button 1 > Pin 16 > CMD “mpc,toggle”. 


The problem I have encountered is that I often need a “double push” in order to play or pause a song. Is this expected behaviour? Can it be tweaked to make it a single push?

Thanks for your help

Up this thread. 
I having a hard time to work with sinlge push button/momentary button to work with play and pause.


Thanks

[the_bertrum]

I've just tried it with the "push" on my rotary encoder and it works every time. Perhaps you need to increase the debounce time?